Showing posts with label stepper motor. Show all posts
Showing posts with label stepper motor. Show all posts

Wednesday, 27 January 2016

Wiring done

Wiring was pretty easy to get done but it looks pretty messy. I have to wrap wires somehow together and think some clever routings. It is important to make sure cables have enough length for the whole movement of the axis. I almost snapped the end stop of from X-axis because I didn't remember it moving higher as the Z increases.

While I was testing the cabling I could not get extruder stepper working. I thought I had burnt driver but in the end it was the 'cold extrusion prevention' feature of the firmware. Simple fix this time. Also, some of the axis were moving to wrong direction but I fixed that in the firmware configuration.

Friday, 4 December 2015

A4988 drivers and Vref adjustment

After verifying the LCD works I went forward with electronics. I placed the heat sinks on the A4988 drivers and plugged them on the RAMPS board. Based on the instructions and markings I placed them right way and started to think about Vref adjustment. This is for the motor current and I followed the instructions on the RepRapWiki. My drivers have Rs=100 Ohm and I wanted to start safe with 0.7A so I adjusted them to have Vref of 570mV.

A4988 drives with heat sinks

Friday, 30 October 2015

NEMA 17 Stepper motors

The printer requires 5 stepper motors. X and Y axis use one each, Z is using two and one for extruder. I spent way too much time figuring out what kind of stepper motors I would get. Based on the information and advices I found, I tried to choose reasonably priced, under 2A stepper with close to 0.44 Nm holding torque. I was trying to make my mind up between 42BYGHW609 and 17HS4417. Both have very similar specs but I was able to find 5 pcs located with 53e shipping included from Germany instead of China. So they should arrive a bit sooner and no need to pay tax or custom fees.